Step 7 — Config & first flights

Everything is mounted. Time for parameters, calibration, and a calm first flight (maiden). Go back to earlier steps if radio, GPS, or power still wobble.…

Step 7 — Config & first flights

Everything is mounted. Time for parameters, calibration, and a calm first flight (maiden). Go back to earlier steps if radio, GPS, or power still wobble. Firmware: firmware page.

Pixhawk 6X Mini — ready for setup

Pixhawk 6X Mini — ready for setup

More images

Stack / module

Stack / module

TX16S for radio calibration

TX16S for radio calibration

What we choose

Manual and stable modes first. Auto and missions only after that. Failsafe, geofence, arming checks, and logging on. PID only in small steps.

What we do

  1. Lock frame type, motor order, ESC protocol (DShot), and battery parameters.
  2. Accel/compass/radio/ESC calibration (without props where required).
  3. Enable failsafe, geofence, arming checks, and logging.
  4. First flights: Stabilize → AltHold → Loiter/PosHold. Only then Auto.
  5. Review logs. Change PID/filters only in small steps.

Manuals

Video

Complete ArduPilot Tuning Guide — Part 1 Hardware and Setup — YouTube

First flight — Stabilize, AltHold, PosHold and Autotune — YouTube

Read next

Done when

Manual/stable modes are reliable. Auto/waypoints have been tested in an open field.

Choice log

What Calibration, failsafe, first flight
Why Until we can fly safely
Our pick Stabilize → AltHold → Loiter first; Auto later; small PID steps

Photos

Leave a Reply

Your email address will not be published. Required fields are marked *