Step 1 — Airframe & mechanics: build the UL8
We start where every craft starts: the frame. On the AOS UL8 V5 we mount motors, ESC, stack, and later every sensor. This step is about strength, vibration, and mounts. Not firmware yet.
More context: what we build. Tools: tools.

AOS UL8 V5 — airframe & build
More images

UL8 V5 render

T-Motor F100

T-Motor Pacer 60A V2
What we choose
We build on a proven 8″ long-range frame. Soft-mount for the stack. Motors and ESC that fit 6S and 8″ props. We stage the props, but we only fit them after power checks.
What we do
- Assemble the UL8 V5 (arms, hardware, soft-mount for the stack).
- Mount F100 1100KV motors and the Pacer 60A V2. Check prop rotation.
- Solder the capacitor from the Pacer kit (or upgrade ~2200 µF @ 35–50 V) onto the ESC power pads — see power & capacitors and Oscar Liang.
- Stage HQProp LR8×4.2×3 (fit only after power checks without props).
- Prep TPU/3D prints for antennas and GPS masts.
Manuals
- AOS UL8 V5 — design
- Chris Rosser — AOS UL V5 build (YouTube)
- T-Motor Pacer 60A V2
- T-Motor F100
- Tools (Bardwell + AliExpress)
Video
AOS UL7/8/10 V5 Build Guides — Chris Rosser — YouTube
Read next
- AOS UL8 V5
- T-Motor F100 1100KV
- T-Motor Pacer 60A V2
- HQProp LR8×4.2×3
- Power & capacitors
- Step 2 — Flight controller & power
Done when
The frame is built. Motors and ESC are secure. The cap is on. Stack and antenna mounts are ready for avionics.
Choice log
| What | Mount frame + propulsion |
| Why | No solid frame means no reliable IMU or stack |
| Our pick | UL8 V5 + F100 + Pacer + HQProp; soft-mount stack; cap on ESC |
Photos



