T-Motor Pacer 60A V2 — 4-in-1 ESC

Pacer 60A V2 — 4-in-1 ESC for the UL8 stack

T-Motor Pacer 60A V2 — 4-in-1 ESC

T-Motor Pacer 60A V2

Pacer 60A V2 — 4-in-1 ESC for the UL8 stack

Four motors need one board. So we ordered the T-Motor Pacer 60A V2: 60 A cont. / ~70 A peak, 3–6S, DShot up to 2400, 30.5 mm stack. Art. 109811 · € 105.00 · 2026-09-06.

Maker: T-Motor Pacer 60A V2.

Why this ESC

It matches the F100 1100KV (~46 A peak per motor) with headroom. Stack pattern matches the Pixhawk Mini (30.5 mm). AOS lists this class for 8″ long-range.

We skipped budget GEPRC without telemetry. No four separate ESCs — too heavy and messy on the UL8. Premium AM32 can wait if we rebuild the stack later.

What we do

Battery ──┬── XT60 ──► Pacer 60A V2 ──► 4× F100 1100KV
          └── XT60 ──► PM02D ──► POWER1 (Pixhawk)
Pixhawk MAIN OUT ──► Pacer (DShot)

The FC gets power from the PM02D, not an ESC BEC. See power & capacitors.

Capacitor (low-ESR)

  • The box includes 1× capacitor (+ XT60, grommets, signal cables).
  • Solder on the ESC power pads, near XT60. Correct polarity. As short as possible.
  • PM02D already has an on-board cap — no loose bulk cap on the PM.
  • For 8″ / 6S: included cap is a start. Aim ~2200 µF or 2× 1000 µF parallel, 35 V or better 50 V (Panasonic FM/FR, Rubycon ZLJ/ZLH). Source: Oscar Liang — capacitors.

DShot on Pixhawk 6X

The 6X has an IOMCU. Put DShot on MAIN OUT (not AUX unless board/firmware allows). No classic ESC calibration with DShot. Test motors without props first (order / direction).

Use thick power wires (12–14 AWG). Pack via XT60.

Specs

Cont. / peak 60 A / ~70 A
Cell count 3–6S
Protocol DShot up to 2400
Mount 30.5×30.5 mm · ~22 g
Size ~41×45×7.2 mm

ArduPilot: DShot · Brushless ESCs · Connect · ESC calibration PWM · BLHeli32 passthrough

AOS: 8″ recommended parts.

Read next

Choice log

What T-Motor Pacer 60A V2 4-in-1 ESC
Why Matches F100 peaks; 30.5 mm stack; DShot/BLHeli32
Our pick Pacer (€105) over budget 4-in-1 or separate ESCs

Photos

Leave a Reply

Your email address will not be published. Required fields are marked *